5Pcs/Pack BIQU TMC2130 Stepper Motor Driver Module with Black Heat Sink 3D Printer Part

5Pcs/Pack BIQU TMC2130 Stepper Motor Driver Module with Black Heat Sink 3D Printer Part

Image
Available: Out of Stock
$66.53 USD
5Pcs/Pack BIQU TMC2130 Stepper Motor Driver Module with Black Heat Sink 3D Printer Part
Introduction:
 
The TMC2130 is a high performance two-phase stepper motor driver chip with a standard SPI interface and a simple step/dir interface. Continuous output current up to 1.2A, can withstand 2A peak current in a short time, very low noise, high load drive does not lose step.

Specifications

1, the subdivision is up to 256;
2. Support SPI interface control;
3. It will not lose the step when driving with high load;
4. The logic interface level is: 3-5V;
5. Input voltage range: 4.75-46V DC;
6, two-phase stepper motor single-phase current 1.2A (peak 2A) motor operating current is adjustable;
7. Default current is 0.76A, maximum current is 2A
8. Quantity:5
BIQU TMC2130 Stepper Motor Driver Module with Black Heat Sink 3D Printer Part

Note:
* The power should be turned on when measuring voltage, not just connected to USB.
* Do not connect the motor when measuring voltage, otherwise it will easily burn the drive.
* Please pay special attention to the direction, do not insert the opposite

Package Included:

5 x Stepper Motor Driver Module with Heat Sink
 
















5Pcs/Pack BIQU TMC2130 Stepper Motor Driver Module with Black Heat Sink 3D Printer Part Introduction:   The TMC2130 is a high performance two-phase stepper motor driver chip with a standard SPI interface and a simple step/dir interface. Continuous output current up to 1.2A, can withstand 2A peak current in a short time, very low noise, high load drive does not lose step.

Specifications

1, the subdivision is up to 256; 2. Support SPI interface control; 3. It will not lose the step when driving with high load; 4. The logic interface level is: 3-5V; 5. Input voltage range: 4.75-46V DC; 6, two-phase stepper motor single-phase current 1.2A (peak 2A) motor operating current is adjustable; 7. Default current is 0.76A, maximum current is 2A
8. Quantity:5
BIQU TMC2130 Stepper Motor Driver Module with Black Heat Sink 3D Printer Part

Note: * The power should be turned on when measuring voltage, not just connected to USB. * Do not connect the motor when measuring voltage, otherwise it will easily burn the drive. * Please pay special attention to the direction, do not insert the opposite

Package Included:

5 x Stepper Motor Driver Module with Heat Sink